Fridge & freezer temperature sensors
Isletek says
Released · 25 October
1
- Idea
- Under review
- Planned
- In progress
- Released
Connected sensors in the fridges, freezers and hot cabinets, so the temperature readings in the Health & Safety checks fill themselves in and nobody walks round with a probe twice a day.
Each unit is paired from Equipment with a token shown once; the sensor posts its readings to Isletek and the Equipment page shows the reading now and the last day as a line. A reading over the limit for longer than the unit's hold time (a defrost or a door held open never counts) opens an excursion with the steps to write down and a recheck 30 minutes later; a sensor that goes quiet raises a task. A typed reading still works for a unit without a sensor.
Part of the Health & Safety checks add-on in the Marketplace.
1 replyfrom Isletek
Isletek · David
This is now live. It’s part of the Health & Safety checks add-on, so it needs installing before you can use it.
To get started:
Open the Marketplace and install Health & Safety checks
Go to Equipment and pick the unit you want to connect
Pair the sensor with the token shown. It only appears once, so copy it straight away. Pairing needs a manager or shop admin.
After that, readings come in on their own and show on the Equipment page. If a reading stays over the limit, Isletek opens an excursion and asks for a recheck. If a sensor goes quiet, it raises a task. Units without a sensor can still have readings typed in as before.
Want this sooner?
Shops on Isletek can reply, ask and vote. You write as your initials.